Updated variable titles for Dimmer/Switch Status to Dimmer/Shade/Switch Status.Īdded Initialize Device Variables section to the driver configuration.Ģ.01ğixed issue where button press events may not get written properly.Ģ.02ğixed typo where All On and All Off in the seeTouch Tabletop Keypad driver commands were reversed.Ģ.1Ědded instrumentation for XPDiagnostics.Īdded Dynamic Naming and Reconfiguration.įixed event triggering for button press and release on IDs above 200.Īdded HVAC Controller and Wireless HVAC Sensor count fields to driver configuration.Ĭhanged driver configuration category and header descriptions. Updated variable titles for Dimmer Level to Dimmer/Shade Level.
The Update Driver feature WILL NOT work with systems using the Lutron RadioRA2.rtidriver.ġ.1 Added HVAC capability with controller and sensor mapping.Īdded Serial capabilities and settings for RS232 compatibility.Ģ.0Ĝreated Full and Lite versions of the driver.Īdded button pressed events for buttons 1-15. The Update Driver feature in Integration Designer will work for updating systems already using any version of the Lutron HomeWorksQS.rtidriver (versions 1.0,1.1,2.0,etc). The Full and Lite versions of the HomeWorksQS driver are no longer needed and have been discontinued. It has not been tested with Quantum Integration Access Points.
Version 2.14 has additionally been tested with QS Standalone (QSE-CI-NWK-E) and a Grafik Eye QS (QSGRJ-3P).
This driver was designed and tested with 2 Lutron HomeWorks QS Processors (HQP6-2-120) via Ethernet and a Lutron Radio RA2 System using the RA2 Main Repeater interface module. Versions 2.24: added undocumented monitoring command suppression, adjustments for monitoring routines, and improved filtering for unwanted responses. Version 2.21: fixes connectivity issue while using serial control with RA2. Version 2.2: adds pushed/released events for ID 1 buttons 1-100, optimized XPDiagnostics print routines, moved general Lutron error responses to XPDiagnostics High log level, recoded connectivity and initialization routines, and adjustments to Button Event naming to reflect more accurate Pico information. Version 2.19: fixes Visor input event execution for press and release events and adds All Off and All On descriptions to Top Raise/Lower events for Table-Top seeTouch Keypads. Version 2.18: include various fixes and adds button release events for keypad buttons 1-15. Version 2.15: fixes issue with RA2 firmware version 7.5 where dimmer and level devices wouldn't update feedback properly. Adds the ability to call scenes directly for QS Standalone/Grafik Eye QS systems. Version 2.14: is an accumulation of fixes and adjustments aimed towards resolving connectivity issues with HomeworksQS version 5.1.0 beta and allowing the driver to be used with QS Standalone via IP or RS232 Control. Version 2.1: rework of the Lite/Full versions of the driver which now supports instrumentation for XP Diagnostics, Dynamic Renaming and Reconfiguration, and other various improvements. VIDEO: Programming using the Lutron Homeworks/QS Driver The Update Driver feature will NOT work with RTI systems currently using the old RadioRA2 driver (version 1.2), which is now discontinued, or systems still using old firmware. The XP firmware must be current for the driver to operate and will only load in Integration Designer 9.0 or greater. PLEASE NOTE: This driver should be used with new RadioRA2, HomeWorks QS, or QS Standalone installations. This driver is for Lutron RadioRA 2 and HomeWorks QS systems connected via Ethernet or RS232.